Read about ‘Microchip: AN – Application Note for Brushless DC Motor Control Using PIC18FXX31 MCUs’ on elementcom. Microchip. leader in motor control, Microchip is continuously designing new motor .. AN Brushless DC Motor Control Using PIC18FXX31 MCU’s. AN Sensorless. AN Brushless DC Motor Control Using PIC18FXX31 MCUs. Author: Padmaraja Yedamale Microchip Technology Inc. HARDWARE A PICDEMâ„¢ MC demo.

Author: Gami Grorr
Country: Dominican Republic
Language: English (Spanish)
Genre: Literature
Published (Last): 14 December 2008
Pages: 153
PDF File Size: 6.56 Mb
ePub File Size: 11.85 Mb
ISBN: 432-1-63093-563-4
Downloads: 10406
Price: Free* [*Free Regsitration Required]
Uploader: Aragrel

Navigation menu Personal tools Create account Log in. Views Read View source View history. Because there is no indication that the motor is moving less than 3mph, if the optical wheel fails for any reason the motorboard will assume that 3mph has not yet been reached.

Since there are eight optical slots on the chopper per turn, this means optical pulses per turn of the wheel.

When you imcrochip the motorboard ON, the green light goes on then off, then the yellow light goes on then off then the red light goes on then off and then the green light goes on solid. If the speed of this motor is less than 3mph, no power will mircochip provided to the motors. The motorboard will not function and there will be no indication as to the cause of failure.


The current code cannot be read because the “Code Protect” bit has been set, but it is possible to erase the chip and program it with new code. Actually it operates at Hz measured. One turn of the wheel is at best inches This prevents power from being applied to the motors until they are at least rotating at 3mph.


Then the operator pushes to go. The motorboard has an automatic low power shut off.

The Roth motorboards “maximum” speed of 18mph translates to optical pulses per second. The motor makes approximately Privacy policy About Motorboards Disclaimers Mobile view. This saves significant amounts of battery power and prevents the motorboard from starting accidentally.

If low power is detected the zn899 LED will blink, and power will be shut off completely. The speed is controlled linearly, and no attempt is made to maintain a given speed for a given throttle position.

Motorboard Controller Source Code (Open Source) – Motorboards

When the battery is almost dead, the red light will blink and the buzzer on the motor contoller PCB will beep on and off 1 second on, 4 seconds off until the battery reaches the low power shut off. This page was last modified on 23 Marchat When the battery gets critically low, the RED light will illuminate. The controller monitors microcuip speed of one of the motors the one with a optical wheel “chopper” attached to an elongated motor shaft.


Retrieved from ” http: