Recommended Practice for. Internal Coating of Line. Pipe for Non-Corrosive Gas. Transmission Service. API RECOMMENDED PRACTICE 5L2 (RP 5L2). API RP 5L2. American Petroleum Institute,. Recommended. Practice for. Internal Coating of Line Pipe for. Non-corrosive Gas Transmission. Service. International . 4 Apr WORLD IRON&STEEL internal pipeline is compliance with all major international standards such as API RP 5L2,Any needs,call for us today!.

Author: Kagakora Kagall
Country: Poland
Language: English (Spanish)
Genre: Literature
Published (Last): 9 August 2013
Pages: 56
PDF File Size: 3.56 Mb
ePub File Size: 18.49 Mb
ISBN: 665-4-83908-272-3
Downloads: 10425
Price: Free* [*Free Regsitration Required]
Uploader: Dojar

Continue test as follows: Unbonded coating shall be completely removed. Heat may be api rp 5l2 to accelerate cure, providing it produces no adverse effects to the pipe or coating.

This applies to coating material that has been thinned to proper application viscosity. We need your help to maintenance this website.

The formulation and publication of API standards is not intended in any way to api rp 5l2 anyone from using any other practices. All other production tests shall be conducted once per shift. The benefits of liquid epoxy coating including: Calculate and report volume solids percentage using values api rp 5l2 above and as follows: Size px x x x x N Casing Tube Gr. Information concerning safety and health risks and proper precautions with respect to aapi materials and conditions should be obtained from the employer, the manufacturer or supplier of that material, or the material safety data sheet.


No part of this work may be reproduced, stored in a retrieval system, or transmitted by any means, electronic, mechanical, photocopying, recording, api rp 5l2 otherwise, without prior written permission from the publisher. P Casing Tube Gr. Application shall be ro by spray on the prepared side of a test panel.

Recommendations made in api rp 5l2 Recommended Practice need not necessarily be considered as minimum standard requirements. Then liquid epoxy is applied to the pipes inner surface by spray guns in a bogey, forming a uniform single layer epoxy which cure after 5l.

H40 Casing Tube Gr. As new materials and practices are developed they will be considered for inclusion in this Recommended Practice.

API RP 5L2:Specification of inter liquid epoxy coating for pipeline | WORLD IRON&STEEL

All testes are to be made in triplicate and reported as the average of same. The test result shall be satisfactory if after 30 minutes of drying upon api rp 5l2 from fog and spray, the coating exhibits no blistering, and not more than 0. T Casing Tube Gr. Weigh aluminum panels in the air to 0. An opaque shield to prevent light interference to observation of the panel being viewed shall support the panel ro a viewing slot.


L Casing Api rp 5l2 Gr.

Pigmented or clear base. The surface to be coated shall be sand blasted to any of the following standards: Cleaning and coating shall be done in separate stages to permit surface api rp 5l2 and prevent coating contamination. Examination of panels shall be made as api rp 5l2 Observe panel within 5 minutes. X60 Line Pipe Gr. gp

Popular Publishers

Coating material deposited on bevels and lands of the pipe ends or in cutback areas shall be removed immediately after coating. A Line Pipe Gr. The back and edges of the panel shall be protected. Coat panels as set api rp 5l2 in Paragraph 3.

Prior to recoating, pipe should be api rp 5l2 cleaned to remove dust and accumulated debris. After the panel or slide is removed, the test area on 5,2 pipe is spot repaired.